My fear is that someone's going to advise a solution along the lines of "cut a surgical hole out the plaster and from there restructure the entire wall with your pinky and then masterfully skim over it and pretend nothing's happened." This is a bit beyond my skill, I think, so I might have to go for option 4 in this insistence. Lots of people seem to advise this, but another miscellaneous man (on a forum this time) said that sometimes very old studs can crack when drilled into?ģ) Use butterfly/molly fixings to just go through the plaster/lath, close your eyes and hope that 6-8 of these across both brackets will be strong enough? A man in a shop told me this, but I haven't read it on any forums, so I'm not sure whether to trust this miscellaneous "man in a shop".Ģ) Find out where the vertical studs are using a cosmically strong magnet and just fix to this, as normal. Poking holes in plaster walls can leave bare lath flapping and loosens the plaster surrounding the opening. If there’s no stud to anchor a lath end, slip a piece of lath into the cavity and screw it to the back of the existing ones, parallel with the studs. Use drywall screws, and always drill pilot holes to avoid splitting the wood. Using a sponge, dampen the sides of the plasterwork inside the hole. Use extra long screws and fix the brackets to this. Lath and plaster is a very old method used for plastering non load bearing petition walls. Step 1 Fix the Lath Photo by Ben Stechschulte Replace any missing lengths of lath, and refasten all loose pieces. Mix the plaster filler as directed to by the instructions that come with it. The traditional method uses lime plaster with goat hair. There are two ways to repair a large hole in plaster, one traditional and one that’s a modern compromise. 1) Use an extra long drill bit to go right through to the brick, and then stick in an extra long raw plug that goes through and into the brick and sits facing out the plaster. Hands down, this is the best product to find studs in a lath and plaster wall.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |